Commercial Waterproofing Tips, Waterproofing Your Tub

It’s almost impossible to keep our bathroom dry. A shower recess has tons of moisture and can also generate steam that can leak through the walls and ceiling of the bathroom, which can cause condensation and variety of problems. Absorbent mats and rugs may keep our feet dry, and keep some parts of the bathroom floor dry, but are not enough to keep moisture off from the bathroom. The best way to keep moisture out is to stop shower leaks, caulk the tub, and secure other sources of leaks before they even start to become a problem. This is what most commercial waterproofing brisbane companies will tell you.

commercial waterproofing brisbane
commercial waterproofing brisbane

 

In caulking your bathtub, here are ten simple steps:

First step

Using graduated markings, trim the angle of a bead cleanup tool for a right-sized notch.

Second Step

Using the utility knife, snip the tip the caulk’s tip. Cut that tip in an angle where you can easily fit the flush into the tight spaces between the tub and the wall. However, should you use the bead head, you don’t need to worry about how you cut the tip.

Third Step

If you’re using a bathtub that needs screwing, mount the bead head through screwing it on the tip of the tub. This will make its own threads.

Fourth Step

Nip the tube to the caulking gun and then pump its trigger until caulk comes out. Wipe off any extra caulk.

Fifth Step

Start in the corner of the bathroom where the tub and the two walls meet. Carefully put the end of the caulk tube to that corner and apply steady pressure to put the bead to that tight seam. Continue until you reach the contrasting wall or other end point. You don’t have to race against time here, just take it slow and do the same to the entire wall.

Sixth Step

With your bead cleanup tool, take off all the extra caulk from the bead. You can do this by simply putting the notched edge of bead cleanup tool in the edge and then follow the seam where it ends. One side should touch the wall, while the other touches the porcelain; the notched corner must be cleared with the bead. L-bend will be accumulated by the extra caulk.

Seventh Step

Take off any excess caulk, then remove any traces of caulk on the surface of the tile or porcelain using a damp cloth or rag. The caulk must be moist and can be wiped off easily.

Eight Step

Do this exact same process on different interior seams. If needed, caulk the outside seams between the tub’s top and the floor top.

Ninth Step

Wet your finger and drag it across the caulk to smoothen and even the surface before it dries up.

Tenth Step

Let the caulk cure and dry up for at least 24 hours or longer before you use the bathtub.

This is what professional commercial waterproofing Melbourne companies will do to stop leaks in your tube. Though this steps may seem simple, this task can be overwhelming for people not comfortable with DIY fixes. If you’re not sure what to do in your waterproofing angle, then call Waterstop Streamline and ask for their help. It’s a highly reputable company in Queensland specializing in home renovations, building, tiling and waterproofing. To know more about their services, visit them online at http://www.waterstopstreamline.com.au/

Leave a Reply

Your email address will not be published. Required fields are marked *